How To Remove The Rust On The Magnet Of The Outer Rotor Brushless DC Motor

How to remove the rust on the magnet of the outer rotor brushless DC motor

There are always some inadvertent operations that cause water to enter our motor. The water entering the motor directly affects the operation of the motor. Because it is rusty, the motor will not run. So how to remove the rust on the motor magnet?

1. Sand it with sandpaper and blow it with the air pump...it doesn't need to be cleaned.

2. After polishing with sandpaper, stick it with transparent tape.

3. Sanding. Wipe with a damp cloth. . Eighty percent of them are like this.

4. I usually use a wet towel! Scrub and wash! Finally wipe the rust away with a dry towel!

5. Wipe it with sandpaper to separate the rust from the magnetic steel; then stick the rust down with children's clay or tape (recommended).

The above are several ways to remove the rust on the magnet of the brushless DC motor. If you also encounter this situation, you may wish to give it a try.